Post-processing greener alternative to IPA for non-professional resins.
Cleaning liquid for non-professional 3D printing resins post-processing.
No more hazardous and polluting post processing procedures, because we care about the environment!
Make your 3D printing greener with TEK 1969, a cleansing liquid which does not dissolve the resin, but it simply separate the uncured resin from the polymerized one.
Methods of Use:
Ultrasonic cleaning (suggested)
Manual with immersion in a container and shake by hand until the resin will be detached from the workpiece.
How to use it in ultrasonic bath
Put the liquid into the ultrasonic vessel
Operate the vessel for 1 minute before cleaning operation
Insert the molded parts to at least 5 minutes into the vessel
Flush with demineralised water (for transparent parts go direct to next point)
Blow dry object with compressed air.
Remove supports if the object is cured enough. (otherwise wait till after the post curing)
The liquid can be filtered with a cloth, or with a TNT (non-woven fabric). TEK 1969 has evaporation rate similar to water: add new liquid when needed.
TEK 1969 is not suitable for professional resins like LumiReact HD. It is an excellent product for titanium cleansing.