Lumi Industries

3D Printing resins, filaments and materials

Lumi Industries sells LumiReact 3D printing resins, Fep, post processing products and filaments. Official Italian distributor of Fun To Do 3D printing resins .

HARZLabs Dental Yellow Clear 3D Printing resin

HARZLabs Dental Yellow Clear 3D Printing resin

from 82.80

3D printing resin designed for surgery guide models.

Add to Cart

3D Printing resin HARZLabs Dental Yellow Clear for surgery guide models.

D YC.jpg

Designed for surgery guide modelling, HARZLabs Dental Yellow Clear is a precise, transparent, very tough, hard and odorless 3D resin. It satisfies ISO 10993 requirements.

Dental Yellow Clear is hard PMMA-like resin, made of biocompatible raw materials, the same used in UV-cured dental fillings.

It has high hardness (92 Shore D) , high tensile strength and stability to mechanical stress.

We recommend to use it for surgical guides and master-model printing. Low odor and absence of harmful monomers allows to print in laboratory without need for special equipment.

Currently under certification process.


Find here more information about 3D printing settings.


3D printing resin HARZLabs Dental Yellow Clear characteristics

 Package                 1kg/0.5kg
 Applications    surgery guide modelling
 Color    Yellow clear, Transparent
 Viscosity (Brookfield)       at 25°C      1-1.2 Pa.s
 Hardness (Shore D)    90-92
 Tensile strenght    60 N/mm2
 Elongation at break    4-6%
 Shrinkage    <0.5%


Dental YC2.jpg



    Models have long-term stability at 100°C making it possible to cast in both cold and hot silicone moulds.


    Resins are odorless and cause no irritation, so you can work with natural ventilation.


    Shrinkage less than 0.5% gives you the same size of the 3D model on your computer


    Produced from biocompatible raw material used in photopolymer teeth fillings. Meets the standards ISO 10993. Currently under certification process.


    Resin is very stable. You can leave it for long time in the vat, no sedimentation and gel formation occur - no need to mix.


    Very high hardness and tensile strength.

Finishing Instructions

  1. Agitate in ultrasonic bath with TEK1969 Detergent or in a vat with TEK1960* solvent for 1-2 minutes to remove excess resin.

  2. Do not soak in acetone. Do not leave the 3D part soaking in the liquid. Use a soft brush if necessary.

  3. Clean off any excess of liquid with a cold blowdryer or compressed air.

  4. Leave under the sun or in a UV lamp to cure. The resin is fully cured when fingernails do not leave scratch marks on the object.

  5. Even after full post cure some parts may still have a sticky surface. You can treat your print with Ta-Tack Away. A quick wash in this special formula will add a stick-free coating on the printed part.Store the resin in a dry, cool, shaded place out of direct sunlight.

*We do not recommend the use of denatured or isopropyl alcohol (IPA). It is very aggressive on the polymerized resin and it could weaken the structure of the 3D part. It is also flammable and potentially harmful to people and the environment.

Store the resin in a dry, cool, shaded place out of direct sunlight.