Lumi Industries

3D Printing resins, filaments and materials

Lumi Industries sells LumiReact 3D printing resins, Fep, post processing products and filaments. Official Italian distributor of Fun To Do 3D printing resins .

HARZLabs Dental Pink 3D Printing Resin

HARZLabs Dental Pink 3D Printing Resin

from 64.80

3D printing resin designed for demonstration models of gingiva.

Add to Cart

3D Printing resin HARZLabs Dental Pink for dental demonstration models of gingiva.

D Peach.png

Designed for dental demonstration models of gingiva, 3D Printing resin HarzLABS Tough, stable resin with a gum semi-transparent color.

Designed for dental demonstration models of gingiva with yellowish pink color. Tough,glossy and stable to deformations.

Dental Pink resin is PMMA-like resin, made of biocompatible raw materials, with gum semitransparent color. It has high hardness 87 Shore D and high tensile strength, stable to mechanical stress.

Recommended for printing of dental model of gum color such as Gingiva mask. Low odor and absence of harmful monomers allows to print in the laboratory, with no need for special equipment.

Currently under certification process.


Find here more information about 3D printing settings.


3D printing resin HARZLabs Dental Pink characteristics

 Package                 1kg/0.5kg
 Applications    dental demonstration models of gingiva
 Color    semitrasparent pink
 Viscosity (Brookfield)       at 25°C      1-1.2 Pa.s
 Hardness (Shore D)   97-90>
 Tensile strenght    60 N/mm2
 Elongation at break    3-4/td>
 Shrinkage    <0.5%


Dental Pink2.jpg



    Very high hardness, tensile strength, abrasion and scratch resistance due to ceramic fillers.


    The resin has relatively low viscosity. It decreases time for levelling, easy to clean to provide maximum accuracy at minimum time.


    Resin is stable to solvents, aggressive inorganic agents like acid and alkalis.


    Resins are odorless and cause no irritation, so you can work with natural ventilation.


    Shrinkage less than 0.5% gives you the same size of the 3D model on your computer


    Produced from biocompatible raw material used in photopolymer teeth fillings. Meets the standards ISO 10993. Currently under certification process.


    Pigments and fillers are well stabilized, no sedimentation and flocculation occur ang no foam appears

Finishing Instructions

  1. Agitate in ultrasonic bath with TEK1969 Detergent or in a vat with TEK1960* solvent for 1-2 minutes to remove excess resin.

  2. Do not soak in acetone. Do not leave the 3D part soaking in the liquid. Use a soft brush if necessary.

  3. Clean off any excess of liquid with a cold blowdryer or compressed air.

  4. Leave under the sun or in a UV lamp to cure. The resin is fully cured when fingernails do not leave scratch marks on the object.

  5. Even after full post cure some parts may still have a sticky surface. You can treat your print with Ta-Tack Away. A quick wash in this special formula will add a stick-free coating on the printed part.

*We do not recommend the use of denatured or isopropyl alcohol (IPA). It is very aggressive on the polymerized resin and it could weaken the structure of the 3D part. It is also flammable and potentially harmful to people and the environment.

Store the resin in a dry, cool, shaded place out of direct sunlight.