Lumi Industries

3D Printing resins, filaments and materials

Lumi Industries sells LumiReact 3D printing resins, Fep, post processing products and filaments. Official Italian distributor of Fun To Do 3D printing resins .

HARZLabs Dental Peach 3D Printing Resin

HARZLabs Dental Peach 3D Printing Resin

from 64.80

3D printing resin designed for demonstration models.

Add to Cart

3D Printing resin HARZLabs Dental Peach for dental demonstration models and master-models.

D Peach.png

Designed for dental demonstration models and master-models, 3D Printing resin HarzLABS Tough, hard, stable to high temperatures during thermoforming aligners

Dental Peach resin is matt pale orange colored resin made of biocompatible raw materials that used in UV-cured dental fillings.

It has high hardness 87 Shore D and high tensile strength, stability to mechanical and thermal stress.

We recommend to use it for demonstration and master-model printing. Low odor and absence of harmful monomers allows to print in the laboratory.

Currently under certification process.



Find here more information about 3D printing settings.

Upon request, Harzlabs Model 3D printing resin is AVAILABLE FOR SLA 3D PRINTERS like Form1/2 e Peopoly,

Just send an email request to:

3D printing resin HARZLabs Dental Peach characteristics


Dental Peach.png

    Very precise resin, able to print dental models where exact size and fitting is a must


    Models has long-term stability under 100°. Also has short-term stability up to 180°C and can be used for films thermosettling


    Resins are odorless and cause no irritation, so you can work with natural ventilation.


    Shrinkage less than 0.5% gives you the same size of the 3D model on your computer


    Produced from biocompatible raw material used in photopolymer teeth fillings. Meets the standards ISO 10993. Currently under certification process.


    Pigments and fillers are well stabilized, no sedimentation and flocculation occur ang no foam appears

Finishing Instructions

  1. Agitate in ultrasonic bath with TEK1969 Detergent or in a vat with TEK1960* solvent for 1-2 minutes to remove excess resin.

  2. Do not soak in acetone. Do not leave the 3D part soaking in the liquid. Use a soft brush if necessary.

  3. Clean off any excess of liquid with a cold blowdryer or compressed air.

  4. Leave under the sun or in a UV lamp to cure. The resin is fully cured when fingernails do not leave scratch marks on the object.

  5. Even after full post cure some parts may still have a sticky surface. You can treat your print with Ta-Tack Away. A quick wash in this special formula will add a stick-free coating on the printed part.

*We do not recommend the use of denatured or isopropyl alcohol (IPA). It is very aggressive on the polymerized resin and it could weaken the structure of the 3D part. It is also flammable and potentially harmful to people and the environment.

Store the resin in a dry, cool, shaded place out of direct sunlight.

Not only for dental purposes

 Package                 1kg/0.5kg
 Applications    dental demonstration models
 Color    Opaque Pale orange
 Viscosity (Brookfield)       at 25°C      1-1.2 Pa.s
 Hardness (Shore D)    85-87
 Tensile strenght    60 N/mm2
 Elongation at break    4-6%
 Shrinkage    <0.5%