Harz Labs Dental Cast 3D Printing resin
Harz Labs Dental Cast 3D Printing resin
3D printing resin designed for printing models used for direct casting.
3D Printing resin Harz Labs Dental Cast for 3D models direct metal casting.
Zero ash content and ready to use in shock cycles. Dental Cast 3D printing resin makes it possible to obtain high quality castings.
Opposite to main casting resins, Harz Labs Dental Cast melts instead of burning, making the casting process much easier.
100% success results with Dental investment materials like Bellavest, Speedvest, Nanovest, Yeti etc.. Also Tested in jewellery with investment materials which can operate at 850°C like Omega+ or Prestige Optima.
Perfect for casting not only with standard metals, but with titanium as well.
Product without european certification, to be used only for models.
COMPATIBLE WITH MAIN DLP/LCD 3D PRINTERS
Find here more information about 3D printing settings.
3D printing resin Harz Labs Dental Cast characteristics
| Package | 1kg/0.5kg | |
| Applications | Dental models to be casted | |
| Color | Red, Cherry, Transparent | |
| Viscosity (Brookfield) | at 25°C | 0.2-0.4 Pa.s |
| Hardness (Shore D) | 40-50 | |
| Ash content | <0.1% | |
| Shrinkage | <1% |
Advantages
ACCURATE
Provides high precision printing and fitting after casting.
ODORLESS
Resins are odorless and cause no irritation.
LOW SHRINKAGE
Shrinkage less than 1% gives you the same size of the 3D model on your computer.
ZERO ASH CONTENT
Close to zero ash content (<0.1%) and high strength makes it possible to cast precise metal and ceramic products.
STABLE
Resin is very stable, you can leave it for a long time in the vat, no sedimentation and gel formation occur - no need to mix.
EASY TO CAST
Resin thermoplastic behavior provides melting in a wide temperature window (250-300°C) to give casted models a very smooth surface..
Finishing Instructions for a perfect casting
To clean and remove excess resin, flash the 3D printed part for 30 seconds, several times until excess resin is removed, in an ultrasonic cleaner with TEK1960 solvent* .
Do not soak in acetone. Do not leave the 3D part soaking in the liquid. Use a soft brush if necessary.
Clean off any excess of liquid with a cold blow-dryer or compressed air.
Leave under a UV lamp postcuring for 30 min until red color becomes pale orange. You are now ready for metal casting.
*We do not recommend the use of denatured or isopropyl alcohol (IPA). It is very aggressive on the polymerized resin and it could weaken the structure of the 3D part. It is also flammable and potentially harmful to people and the environment.
Store the resin in a dry, cool, shaded place out of direct sunlight.
Safe notice
The company I.D.M di Marin Davide is not a manufacturer of medical materials or devices. The material sold on this site is neither produced nor controlled by the company I.D.M. di Marin Davide, who in no case can be held responsible for any damage caused by use or application of the material, which must only be used on suitable machines and by specialized personnel, exclusively for the purpose indicated, according to the manufacturer's instructions. For resins with European certification, the properties of the finished product vary according to the entire printing and post-curing process; refer to the manufacturer for any information about it.